How to Lay Porcelain Slabs Outdoors: Step by Step

Tools & Materials Required

Tools: string line & pegs, spirit level, tape measure, rake, shovel, wheelbarrow, trowel, wide paint brush, drill with mixing paddle, rubber mallet, broom & brush, buckets & sponge, joint spacers, grouting tool.

Optional hire tools: mixer, vibrating plate, table saw, electric angle grinder, diamond cutting blade.

Materials: MOT Type 1 (sub-base), sharp sand, cement, slurry primer, flexible grout.

Safety gear: gloves, dust mask, safety glasses, ear protection.

Ground Preparation for Porcelain Paving

1. Ground Preparation

  • Dig ground to 150–160mm depth, firm soil at bottom.
  • Test by heel—if it sinks, dig further until firm.
  • Allow correct fall for drainage: 1cm fall for every 60cm of paving.
  • Mark out levels with string line and pegs.
Lay Sub Base for Porcelain Patio

2. Lay the Sub-Base

  • Spread MOT Type 1 to about 30mm below the string line.
  • Compact with vibrating plate at least 7 times to 100mm thickness.
  • Leave 60mm below the line for mortar and slabs.
Mix Mortar for Porcelain Slabs

3. Mix and Apply Mortar

  • Mix 5 parts sharp sand : 1 part cement + water.
  • Use a mixer for consistency.
  • Mix until smooth and creamy, ready to apply.
Prime Porcelain Slabs

4. Prime the Slabs

  • Mix slurry primer with water per instructions.
  • Brush primer over entire back surface of each slab.
  • This ensures strong adhesion to mortar for 900x600mm porcelain paving and other sizes.
Lay Porcelain Slabs

5. Lay the Porcelain Slabs

  • Apply a full mortar bed 10–15mm below string line.
  • Place primed slab, tap gently with rubber mallet.
  • Check levels and fall direction using a spirit level.
  • Use spacers between slabs for perfect alignment.
Cut Porcelain Slabs

6. Cutting Slabs (if necessary)

  • Cut using table saw, wet saw, or angle grinder with diamond blade.
  • Take your time for precise or curved cuts, especially with 600x600mm porcelain tiles.
Grouting Porcelain Patio

7. Grouting

  • Ensure surface is clean and dry before applying grout.
  • Mix 1.2L water to 5kg grout powder.
  • Apply using grout float or gun, fill joints completely.
  • Wipe excess and clean with damp sponge.
Final Finish of Porcelain Patio

8. Final Clean & Finish

  • Wipe slabs with clean sponge to remove residue.
  • Ensure joints are smooth and even.
  • Enjoy your beautifully laid porcelain patio!

9. Customer's Garden

See the complete step-by-step process in action: